Niagara Cutter 5/8

Description

Two-flute designs offer the efficient chip removal, but more flutes provide a smoother finish. The Niagara Cutter C430 TiAlN-coated carbide square nose end mill has four flutes and a 30-degree helix angle for general-purpose machining on a range of materials. It balances lower angles strong cutting edge for difficult-to-machine materials with higher angles increased cutting action. The tools square end creates sharp, unrounded cuts, and the center-cutting design has cutting teeth at the end of the tool, so it can be fed into the workpiece like a drill bit. Non-center-cutting end mills are for applications such as peripheral milling and finishing, but cannot make plunge cuts. (TiAlN is suitable for a range of materials, but TiCN or uncoated end mills are recommended for machining aluminum.) The carbide substrate is harder than high-speed or cobalt steel, making it more wear resistant at high speeds and. End mills are designed to remove material and create multi-dimensional shapes and profiles. The shank is the end of the tool held in place by a tool holder or machine. Niagara Cutter has been designing and manufacturing precision cutting tools since 1954. If heat is not reduced effectively, the tools cutting edges will dull and additional material buildup can occur. The TiAlN coating resists heat better than TiN and TiCN coatings, increasing tool life and performance. The 30-degree helix angle supports general-purpose applications.

Key Features

• (TiAlN is suitable for a range of materials, but TiCN or uncoated end mills are recommended for machining aluminum.) The carbide substrate is harder than high-speed or cobalt steel, making it more wear resistant at high speeds and.
• The 30-degree helix angle supports general-purpose applications.
• They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter.
• Two-flute designs offer the efficient chip removal, but more flutes provide a smoother finish.
• End mills are designed to remove material and create multi-dimensional shapes and profiles.
• The Niagara Cutter C430 TiAlN-coated carbide square nose end mill has four flutes and a 30-degree helix angle for general-purpose machining on a range of materials.